Home General Accessories

General Accessories

Via its association in Vietnam with Maxell Marine, Ocean Cruiser Company can supply, not only your anchor winch or capstan, but also a complete anchoring package consisting of control gear, circuit protection, anchors, rope, chain, chain stoppers etc. When it comes to anchoring, Maxwell provides the ultimate anchoring solution backed by sound advice and after sales services.

Accessories Positioning Guide
The correct installation of your Maxwell windlass or capstan and all associated anchoring equipment will ensure that you get years of trouble free service. It is worth taking the time to install all accessories and electrical wiring or hydraulic connections carefully and professionally. Your Maxwell Owner's Manual will provide you with all the information you need to properly set up your specific installation. The indicative diagram gives you some idea of what is involved and is a guide only.

 

Ocean Cruiser Company :: Vietnam | Maxell Marine General Boating Accessories Diagram

 

Chain Stoppers

Vietnam | Maxell Marine Chain StopperChain stoppers stop the chain and take the load off the windlass. They are used to set and ride on the anchor, break free the anchor or to prevent accidental 'free-fall' of the anchor while under way. Also recommended for VW series rope and chain systems to hold the chain while changing over from rope to chain. Available in 8mm (5/16"), 10mm (3/8"), 13mm (1/2"). Larger versions available in the Maxwell Superyacht range of products.

Last Updated ( Wednesday, 24 December 2008 08:30 ) Read more...
 

Ropes, Chains and Anchors

Ocean Cruiser Company :: Vietnam Maxell Marine Pats :: Ropes and ChainsMaxwell can supply a full range of anchor rodes including chain only, rope only or pre-spliced combination rope and chain rodes. Chain, suitable for vessels from 6 metres (20 feet) to over 60 metres (200 feet), is available in short or stud link variations in both metric and imperial sizes. Maxwell stocks both 3-strand and 8 plait braid nylon rope commonly used on vessels up to 20 metres (65 feet) as well as ropes and hawsers commonly seen on superyachts.

There are a wide variety and range of anchors on today's market. Maxwell takes pride in being able to source the highest quality galvanized and stainless steel anchors available. Contact Maxwell to discuss your specific requirements.

Last Updated ( Wednesday, 24 December 2008 08:45 )
 

Deck Gear and Solenoids

Ocean Cruiser Company :: Vietnam Yacht Charter, Sales, Parts and Marina Management and DesignAUTOCLEAT - FROM MAXWELL MARINE
The ultimate mooring cleat.

PUSH BUTTON MOORING LINE RELEASE
Imagine being able to release your boat’s mooring lines at the press of a button. No more turning your guests into crew, complete control at the push of a button. The AutoCleat will release any line configuration - loop, figure 8 or slip knot.

CLEAR DECKS AND PASSAGEWAYS
Smart boat design means clever utilization of every space and surface available. The AutoCleat provides a strong, secure mooring point while berthed and when not required, retracts flush at the push of a button leaving those valuable surfaces uncluttered. No more stubbed toes and no more snagged fishing lines or halyards.

DESIGNED AND BUILT TO LAST
Cast from a high strength, corrosion resistant stainless steel, the horns of the AutoCleat give exceptional high side-load carrying capacity. With the remaining components manufactured from marine grade materials and composites, the AutoCleat comes complete with a 3 year warranty against manufacturing defects

Last Updated ( Thursday, 25 December 2008 19:37 ) Read more...
 

Switches & Breaker/isolators

Ocean Cruiser Company :: Vietnam | Maxwell Marine Parts Switches and Breaker and isolators UP/DOWN CONTROL
Easy to use panel-mounted Up/Down switches for remote windlass operation from the helm, flying bridge or cockpit. Available for use (A) with or (B) without dual-directional solenoids.

  • Manufactured from marine-grade materials
  • Splash proof
  • Includes power indicator light and back lighting (version A only)
  • Available in 12V or 24V DC versions.
Last Updated ( Wednesday, 24 December 2008 12:24 ) Read more...
 

Rode Counters

Control gear

All rode counters feature:

  • Windlass monitoring from the helm.
  • Simple Plug & Play sensor installation.
  • Accurate information for all-chain or combination rope/chain rodes.
  • Flexibility of magnet and sensor gap from 3mm to 50mm.
  • Easy set up.
  • Multiple unit installation options – combine with other Maxwell AA products for total windlass control.
  • Fit any windlass including AC and hydraulic.
  • Inbuilt diagnostics for troubleshooting installation issues.
  • EMC protection to CE EN60945
Last Updated ( Friday, 26 December 2008 14:22 ) Read more...